IU0REK-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU0REK-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1788564658	13.43 Volt	24 C
1788563156	13.43 Volt	25 C
1788561654	13.43 Volt	25 C
1788560153	13.43 Volt	25.5 C
1788558652	13.43 Volt	26 C
1788557150	13.43 Volt	26 C
1788555649	13.43 Volt	26 C
1788554147	13.43 Volt	26.5 C
1788552646	13.43 Volt	27 C
1788551144	13.43 Volt	27.5 C
1788549643	13.43 Volt	28 C
1788548142	13.43 Volt	28.5 C
1788546640	13.43 Volt	29 C
1788545139	13.43 Volt	30 C
1788543637	13.43 Volt	30.5 C
1788542136	13.5 Volt	32 C
1788540634	13.8 Volt	33.5 C
1788539133	14.33 Volt	34 C
1788537632	14.4 Volt	35 C
1788536130	14.25 Volt	36 C
1788534629	14.25 Volt	37 C
1788533127	14.18 Volt	38 C
1788531626	14.25 Volt	38 C
1788530124	14.1 Volt	37.5 C
1788528623	14.48 Volt	37 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)