OE3TPB-29 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE3TPB-29. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1784688782	0 C deg	14.7 C deg
1784686964	0 C deg	14.9 C deg
1784685147	0 C deg	15.7 C deg
1784683338	0 C deg	16.2 C deg
1784681517	0 C deg	16.4 C deg
1784679703	0 C deg	16.9 C deg
1784676080	0 C deg	17.1 C deg
1784674263	0 C deg	17.4 C deg
1784672441	0 C deg	18.1 C deg
1784670630	0 C deg	18.8 C deg
1784668811	0 C deg	19.2 C deg
1784667000	0 C deg	19.9 C deg
1784665182	0 C deg	20.4 C deg
1784663372	0 C deg	20.7 C deg
1784661561	0 C deg	20.7 C deg
1784659739	0 C deg	21.2 C deg
1784657925	0 C deg	21.5 C deg
1784656107	0 C deg	22.1 C deg
1784654291	0 C deg	23 C deg
1784650659	0 C deg	23.9 C deg
1784648846	0 C deg	24.2 C deg
1784647029	0 C deg	24.4 C deg
1784645221	0 C deg	25.8 C deg
1784643401	0 C deg	24.6 C deg
1784641585	0 C deg	26.2 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)