SQ9KFP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFP-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780150188	13 Count	135 Count
1780147486	10 Count	112 Count
1780145685	8 Count	91 Count
1780144797	3 Count	75 Count
1780143897	2 Count	64 Count
1780142996	1 Count	44 Count
1780141195	107 Count	1008 Count
1780140294	106 Count	994 Count
1780139394	105 Count	978 Count
1780138493	104 Count	964 Count
1780137593	103 Count	950 Count
1780136692	102 Count	922 Count
1780135791	101 Count	906 Count
1780134891	100 Count	886 Count
1780134106	99 Count	858 Count
1780133090	98 Count	845 Count
1780132189	97 Count	834 Count
1780131289	96 Count	825 Count
1780130388	95 Count	808 Count
1780129487	94 Count	795 Count
1780127686	92 Count	779 Count
1780126786	91 Count	752 Count
1780125885	90 Count	742 Count
1780124985	89 Count	737 Count
1780124084	88 Count	734 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)