CS7AUX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CS7AUX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1777958529	814 Count	4.2 VDC
1777957629	813 Count	4.18 VDC
1777956728	812 Count	4.15 VDC
1777955827	811 Count	4.2 VDC
1777954926	810 Count	4.19 VDC
1777954026	809 Count	4.15 VDC
1777953125	808 Count	4.15 VDC
1777952224	807 Count	4.19 VDC
1777951323	806 Count	4.19 VDC
1777950423	805 Count	4.18 VDC
1777949522	804 Count	4.16 VDC
1777948621	803 Count	4.19 VDC
1777947721	802 Count	4.18 VDC
1777946820	801 Count	4.19 VDC
1777945919	800 Count	4.18 VDC
1777945018	799 Count	4.16 VDC
1777944118	798 Count	4.17 VDC
1777943217	797 Count	4.21 VDC
1777942316	796 Count	4.16 VDC
1777941416	795 Count	4.2 VDC
1777940531	794 Count	4.19 VDC
1777939630	793 Count	4.2 VDC
1777938730	792 Count	4.17 VDC
1777937829	791 Count	4.21 VDC
1777936928	790 Count	4.16 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)