LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789945645	406 Count	328 Count	289 Count
1789943842	402 Count	325 Count	286 Count
1789942038	399 Count	323 Count	284 Count
1789940235	397 Count	322 Count	283 Count
1789938432	393 Count	320 Count	281 Count
1789936629	388 Count	317 Count	278 Count
1789934825	384 Count	314 Count	275 Count
1789933021	380 Count	311 Count	272 Count
1789931217	376 Count	308 Count	269 Count
1789929413	372 Count	305 Count	266 Count
1789927655	368 Count	302 Count	263 Count
1789909617	324 Count	269 Count	230 Count
1789907813	321 Count	267 Count	228 Count
1789906051	318 Count	265 Count	226 Count
1789904248	314 Count	262 Count	223 Count
1789902444	310 Count	259 Count	220 Count
1789900640	306 Count	256 Count	217 Count
1789898837	302 Count	253 Count	214 Count
1789897034	298 Count	250 Count	211 Count
1789895231	294 Count	247 Count	208 Count
1789893427	289 Count	243 Count	204 Count
1789891624	285 Count	240 Count	201 Count
1789889820	281 Count	237 Count	198 Count
1789888016	277 Count	234 Count	195 Count
1789886212	273 Count	231 Count	192 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)