OE4EXE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE4EXE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788568223	48 Count	558 Count
1788567779	47 Count	549 Count
1788567175	46 Count	530 Count
1788566571	45 Count	510 Count
1788565968	44 Count	495 Count
1788565363	43 Count	480 Count
1788564760	42 Count	462 Count
1788564156	41 Count	448 Count
1788563552	40 Count	434 Count
1788562949	39 Count	425 Count
1788562345	38 Count	414 Count
1788561741	37 Count	403 Count
1788561137	36 Count	394 Count
1788560534	35 Count	384 Count
1788559930	34 Count	379 Count
1788559326	33 Count	367 Count
1788558723	32 Count	355 Count
1788558119	31 Count	342 Count
1788557515	30 Count	330 Count
1788556912	29 Count	320 Count
1788556308	28 Count	311 Count
1788555704	27 Count	298 Count
1788555101	26 Count	282 Count
1788554497	25 Count	269 Count
1788553893	24 Count	253 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)