OE1KDA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE1KDA-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1788594798	0 C deg	21.8 C deg
1788592986	0 C deg	21.8 C deg
1788591170	0 C deg	21.8 C deg
1788589353	0 C deg	22.4 C deg
1788560311	0 C deg	25.1 C deg
1788558495	0 C deg	25.8 C deg
1788556681	0 C deg	26.4 C deg
1788554867	0 C deg	27 C deg
1788553063	0 C deg	27.9 C deg
1788551236	0 C deg	28.8 C deg
1788549423	0 C deg	29.1 C deg
1788547605	0 C deg	29.3 C deg
1788545793	0 C deg	29.6 C deg
1788543985	0 C deg	29.9 C deg
1788542160	0 C deg	30.2 C deg
1788540348	0 C deg	30.6 C deg
1788538531	0 C deg	31 C deg
1788536745	0 C deg	31.2 C deg
1788534900	0 C deg	31.7 C deg
1788533128	0 C deg	32.2 C deg
1788531285	0 C deg	33.2 C deg
1788529455	0 C deg	35.8 C deg
1788527639	0 C deg	34.7 C deg
1788525834	0 C deg	35.6 C deg
1788524008	0 C deg	35.1 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)