EA4CPM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4CPM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772526643	351 Count	543 Count	283 Count
1772524840	342 Count	526 Count	275 Count
1772523037	335 Count	513 Count	269 Count
1772521233	329 Count	498 Count	264 Count
1772519430	322 Count	486 Count	258 Count
1772517627	316 Count	474 Count	253 Count
1772515824	310 Count	459 Count	248 Count
1772514020	299 Count	428 Count	238 Count
1772512217	289 Count	410 Count	229 Count
1772510414	278 Count	393 Count	219 Count
1772508646	269 Count	377 Count	211 Count
1772506847	260 Count	360 Count	203 Count
1772505040	253 Count	347 Count	197 Count
1772504037	137 Count	178 Count	107 Count
1772503236	242 Count	329 Count	187 Count
1772501433	236 Count	318 Count	182 Count
1772499630	227 Count	301 Count	174 Count
1772497827	216 Count	280 Count	164 Count
1772494220	199 Count	253 Count	149 Count
1772492417	191 Count	237 Count	142 Count
1772491435	124 Count	174 Count	103 Count
1772490614	183 Count	223 Count	135 Count
1772488810	174 Count	209 Count	127 Count
1772487046	166 Count	194 Count	120 Count
1772485242	162 Count	189 Count	117 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)