F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776635954	104 Count	121 Count	90 Count
1776635350	96 Count	112 Count	83 Count
1776634746	88 Count	103 Count	76 Count
1776634143	77 Count	90 Count	66 Count
1776633539	70 Count	82 Count	60 Count
1776632936	62 Count	73 Count	53 Count
1776632332	52 Count	59 Count	44 Count
1776631729	42 Count	46 Count	35 Count
1776631129	33 Count	36 Count	27 Count
1776630526	22 Count	21 Count	17 Count
1776629922	15 Count	12 Count	11 Count
1776629319	800 Count	1008 Count	712 Count
1776628715	790 Count	995 Count	703 Count
1776628106	779 Count	981 Count	693 Count
1776627503	773 Count	974 Count	688 Count
1776626899	761 Count	958 Count	677 Count
1776626296	752 Count	947 Count	669 Count
1776625693	742 Count	935 Count	660 Count
1776625090	732 Count	923 Count	651 Count
1776624483	721 Count	910 Count	641 Count
1776623878	713 Count	900 Count	634 Count
1776623275	702 Count	888 Count	624 Count
1776622672	694 Count	877 Count	617 Count
1776622068	685 Count	865 Count	609 Count
1776621465	674 Count	852 Count	599 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)