EC5CIA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780627853	4 Count	905 Count
1780626953	4 Count	905 Count
1780626053	4 Count	905 Count
1780625153	4 Count	905 Count
1780624252	4 Count	905 Count
1780623353	4 Count	905 Count
1780622452	4 Count	905 Count
1780621552	4 Count	905 Count
1780620652	4 Count	905 Count
1780619752	4 Count	905 Count
1780618852	4 Count	905 Count
1780617952	4 Count	905 Count
1780617052	4 Count	905 Count
1780616152	4 Count	905 Count
1780615253	4 Count	905 Count
1780614353	4 Count	905 Count
1780613453	4 Count	905 Count
1780612553	4 Count	905 Count
1780611652	4 Count	905 Count
1780610752	4 Count	905 Count
1780609852	4 Count	905 Count
1780608952	4 Count	905 Count
1780608052	4 Count	905 Count
1780607152	4 Count	905 Count
1780606252	4 Count	905 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)