IQ5VK-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IQ5VK-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	CPU Temp*	CPU Load*
1765575306	39.3 Deg.C	61 %
1765575005	39.7 Deg.C	60 %
1765574706	40.2 Deg.C	60 %
1765574405	40.2 Deg.C	61 %
1765574107	41 Deg.C	61 %
1765573805	39.2 Deg.C	60 %
1765573506	40.6 Deg.C	60 %
1765573206	41.5 Deg.C	53 %
1765572906	40.9 Deg.C	63 %
1765572606	41 Deg.C	62 %
1765572306	41.2 Deg.C	62 %
1765572006	40.9 Deg.C	63 %
1765571706	42.1 Deg.C	62 %
1765571406	40.8 Deg.C	61 %
1765571106	42.5 Deg.C	63 %
1765570806	41 Deg.C	63 %
1765570506	41.6 Deg.C	61 %
1765570206	41.4 Deg.C	63 %
1765569905	41.6 Deg.C	62 %
1765569606	41.2 Deg.C	53 %
1765569305	41.9 Deg.C	61 %
1765568705	42.4 Deg.C	62 %
1765568406	42.1 Deg.C	62 %
1765567822	42.9 Deg.C	62 %
1765567505	43.7 Deg.C	64 %

*Used Equation Coefficients:

CPU Temp: 0, 0.1, 0

CPU Load: 0, 1, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)