SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773262043	304 Count	285 Count	231 Count
1773260242	299 Count	280 Count	227 Count
1773258441	294 Count	275 Count	223 Count
1773256640	290 Count	272 Count	220 Count
1773254839	285 Count	268 Count	216 Count
1773253039	280 Count	263 Count	212 Count
1773251245	271 Count	258 Count	208 Count
1773249445	266 Count	254 Count	204 Count
1773247644	261 Count	249 Count	200 Count
1773244045	250 Count	240 Count	191 Count
1773242242	241 Count	227 Count	183 Count
1773240441	224 Count	207 Count	167 Count
1773238640	219 Count	202 Count	163 Count
1773236840	214 Count	198 Count	159 Count
1773235039	210 Count	195 Count	156 Count
1773233238	205 Count	191 Count	152 Count
1773231438	200 Count	187 Count	148 Count
1773229645	192 Count	183 Count	145 Count
1773226044	182 Count	175 Count	137 Count
1773222442	173 Count	168 Count	130 Count
1773215240	153 Count	152 Count	114 Count
1773208043	124 Count	128 Count	93 Count
1773206242	119 Count	123 Count	89 Count
1773204441	114 Count	115 Count	85 Count
1773202641	109 Count	109 Count	81 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)