IT9IJY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753629928	471 Count	711 Count	416 Count
1753629024	463 Count	700 Count	409 Count
1753628120	454 Count	685 Count	401 Count
1753627319	445 Count	669 Count	393 Count
1753625511	428 Count	645 Count	378 Count
1753624607	420 Count	633 Count	371 Count
1753623703	412 Count	621 Count	364 Count
1753621892	396 Count	593 Count	350 Count
1753620988	387 Count	581 Count	342 Count
1753620085	379 Count	567 Count	335 Count
1753619181	370 Count	553 Count	327 Count
1753617374	351 Count	525 Count	310 Count
1753616470	342 Count	513 Count	302 Count
1753615566	332 Count	496 Count	293 Count
1753613759	313 Count	464 Count	276 Count
1753612850	305 Count	450 Count	269 Count
1753611947	299 Count	439 Count	264 Count
1753611043	292 Count	423 Count	258 Count
1753610139	282 Count	411 Count	249 Count
1753609231	274 Count	400 Count	242 Count
1753608327	267 Count	390 Count	236 Count
1753607423	259 Count	376 Count	229 Count
1753606520	250 Count	359 Count	221 Count
1753605739	243 Count	344 Count	215 Count
1753604817	236 Count	328 Count	209 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)