SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788591463	575 Count	219 Count	117 Count
1788589782	554 Count	209 Count	113 Count
1788588101	538 Count	200 Count	110 Count
1788586421	521 Count	191 Count	106 Count
1788584740	503 Count	182 Count	103 Count
1788583059	485 Count	173 Count	99 Count
1788581628	465 Count	164 Count	95 Count
1788579947	446 Count	154 Count	91 Count
1788578267	430 Count	146 Count	88 Count
1788576586	413 Count	137 Count	85 Count
1788574905	398 Count	128 Count	82 Count
1788573224	378 Count	124 Count	78 Count
1788571543	361 Count	120 Count	74 Count
1788569862	343 Count	116 Count	70 Count
1788568181	325 Count	112 Count	66 Count
1788566501	309 Count	109 Count	63 Count
1788564820	291 Count	105 Count	59 Count
1788563139	274 Count	102 Count	56 Count
1788560027	236 Count	94 Count	48 Count
1788558346	217 Count	90 Count	44 Count
1788556665	201 Count	87 Count	41 Count
1788554984	180 Count	82 Count	36 Count
1788553304	163 Count	78 Count	32 Count
1788551623	145 Count	74 Count	28 Count
1788549942	127 Count	70 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)