SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784740692	292 Count	218 Count	70 Count
1784738890	291 Count	218 Count	70 Count
1784737088	290 Count	218 Count	70 Count
1784735287	289 Count	218 Count	70 Count
1784733486	288 Count	218 Count	70 Count
1784731685	287 Count	218 Count	70 Count
1784729884	279 Count	211 Count	63 Count
1784728083	278 Count	210 Count	63 Count
1784726282	277 Count	210 Count	63 Count
1784724481	276 Count	210 Count	63 Count
1784722680	275 Count	210 Count	63 Count
1784720879	274 Count	210 Count	63 Count
1784675885	266 Count	203 Count	56 Count
1784674084	265 Count	203 Count	56 Count
1784672283	264 Count	203 Count	56 Count
1784670481	263 Count	203 Count	56 Count
1784668680	262 Count	203 Count	56 Count
1784666879	261 Count	203 Count	56 Count
1784665078	260 Count	203 Count	56 Count
1784663276	259 Count	203 Count	56 Count
1784661475	258 Count	203 Count	56 Count
1784659675	257 Count	203 Count	56 Count
1784657874	256 Count	203 Count	56 Count
1784656072	255 Count	203 Count	56 Count
1784634474	243 Count	203 Count	56 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)