SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788572843	261 Count	732 Count	217 Count
1788571042	257 Count	719 Count	214 Count
1788569241	253 Count	706 Count	211 Count
1788567441	249 Count	693 Count	208 Count
1788565674	245 Count	680 Count	205 Count
1788563839	241 Count	668 Count	202 Count
1788562039	234 Count	648 Count	196 Count
1788560263	230 Count	636 Count	193 Count
1788558442	226 Count	623 Count	190 Count
1788556644	222 Count	610 Count	187 Count
1788554844	218 Count	597 Count	184 Count
1788553062	215 Count	582 Count	182 Count
1788551242	211 Count	569 Count	179 Count
1788549442	207 Count	556 Count	176 Count
1788547641	203 Count	543 Count	173 Count
1788545840	199 Count	530 Count	170 Count
1788544040	194 Count	514 Count	166 Count
1788542239	178 Count	480 Count	151 Count
1788540438	158 Count	441 Count	132 Count
1788538637	154 Count	428 Count	129 Count
1788536837	150 Count	415 Count	126 Count
1788535044	146 Count	400 Count	123 Count
1788533243	139 Count	381 Count	117 Count
1788531442	133 Count	361 Count	112 Count
1788529641	124 Count	339 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)