IZ1RFL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ1RFL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	V_Bat*
1788568042	139 Count	4.23 VDC
1788554449	53 Count	4.21 VDC
1788553547	51 Count	4.22 VDC
1788552647	45 Count	4.18 VDC
1788551747	42 Count	4.24 VDC
1788550847	37 Count	4.27 VDC
1788549946	35 Count	4.24 VDC
1788549046	31 Count	4.25 VDC
1788548146	31 Count	4.24 VDC
1788547246	28 Count	4.22 VDC
1788546345	25 Count	4.23 VDC
1788545444	21 Count	4.21 VDC
1788544544	19 Count	4.25 VDC
1788540027	3 Count	4.23 VDC
1788539127	1003 Count	4.21 VDC
1788538235	999 Count	4.24 VDC
1788537327	997 Count	4.24 VDC
1788536427	993 Count	4.21 VDC
1788535527	989 Count	4.24 VDC
1788534627	983 Count	4.25 VDC
1788533751	972 Count	4.27 VDC
1788532826	958 Count	4.2 VDC
1788531926	954 Count	4.28 VDC
1788531026	947 Count	4.27 VDC
1788530126	945 Count	4.19 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)