SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788570108	774 Count	911 Count	71 Count
1788568428	772 Count	908 Count	70 Count
1788566747	770 Count	905 Count	69 Count
1788565066	768 Count	902 Count	68 Count
1788563385	766 Count	899 Count	67 Count
1788561705	764 Count	893 Count	66 Count
1788560024	763 Count	891 Count	66 Count
1788558343	761 Count	888 Count	65 Count
1788556662	759 Count	885 Count	64 Count
1788554982	757 Count	882 Count	63 Count
1788553301	755 Count	880 Count	62 Count
1788551869	749 Count	878 Count	61 Count
1788550188	747 Count	874 Count	60 Count
1788548507	745 Count	871 Count	59 Count
1788546827	743 Count	868 Count	58 Count
1788545146	741 Count	865 Count	57 Count
1788543465	739 Count	853 Count	56 Count
1788541784	737 Count	845 Count	55 Count
1788540104	735 Count	836 Count	54 Count
1788538423	734 Count	834 Count	54 Count
1788536747	732 Count	831 Count	53 Count
1788535061	731 Count	831 Count	53 Count
1788533381	730 Count	831 Count	53 Count
1788531700	729 Count	831 Count	53 Count
1788530268	724 Count	831 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)