SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1789889970	539 Count	14 Count	14 Count
1789888290	538 Count	14 Count	14 Count
1789886609	536 Count	14 Count	14 Count
1789808029	504 Count	9 Count	9 Count
1789802986	496 Count	4 Count	4 Count
1789799625	493 Count	4 Count	4 Count
1789755274	487 Count	4 Count	4 Count
1789737035	468 Count	0 Count	0 Count
1789735354	467 Count	0 Count	0 Count
1789733673	466 Count	0 Count	0 Count
1789721908	459 Count	0 Count	0 Count
1789670165	444 Count	0 Count	0 Count
1789668484	443 Count	0 Count	0 Count
1789666803	442 Count	0 Count	0 Count
1789665122	440 Count	0 Count	0 Count
1789663692	436 Count	0 Count	0 Count
1789662024	435 Count	0 Count	0 Count
1789660330	434 Count	0 Count	0 Count
1789653606	430 Count	0 Count	0 Count
1789486514	348 Count	0 Count	0 Count
1789240686	258 Count	0 Count	0 Count
1789235643	254 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)