SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765501237	423 Count	534 Count	353 Count
1765499436	413 Count	520 Count	344 Count
1765495835	390 Count	489 Count	323 Count
1765494034	379 Count	474 Count	313 Count
1765492232	366 Count	457 Count	301 Count
1765488631	337 Count	429 Count	284 Count
1765486830	325 Count	412 Count	275 Count
1765485030	312 Count	396 Count	263 Count
1765479628	246 Count	333 Count	217 Count
1765459821	128 Count	176 Count	110 Count
1765458049	117 Count	166 Count	104 Count
1765456248	110 Count	155 Count	98 Count
1765452647	92 Count	129 Count	82 Count
1765450846	84 Count	117 Count	75 Count
1765449049	76 Count	105 Count	68 Count
1765447245	69 Count	95 Count	62 Count
1765445444	59 Count	82 Count	53 Count
1765443644	47 Count	67 Count	42 Count
1765441843	39 Count	55 Count	35 Count
1765440042	30 Count	43 Count	27 Count
1765438242	19 Count	28 Count	17 Count
1765436441	12 Count	19 Count	11 Count
1765434641	7 Count	10 Count	7 Count
1765432840	736 Count	1006 Count	631 Count
1765431039	728 Count	994 Count	624 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)