LW2DHT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784775887	523 Count	686 Count	393 Count
1784774084	518 Count	681 Count	389 Count
1784772280	513 Count	677 Count	385 Count
1784770477	508 Count	672 Count	381 Count
1784768675	502 Count	645 Count	376 Count
1784766871	497 Count	629 Count	372 Count
1784763265	487 Count	506 Count	364 Count
1784761462	483 Count	471 Count	361 Count
1784759659	478 Count	465 Count	357 Count
1784757856	473 Count	453 Count	353 Count
1784756052	468 Count	447 Count	349 Count
1784752481	454 Count	437 Count	341 Count
1784750677	449 Count	432 Count	337 Count
1784747071	439 Count	423 Count	329 Count
1784743465	427 Count	411 Count	319 Count
1784741662	422 Count	406 Count	315 Count
1784739859	417 Count	401 Count	311 Count
1784738056	412 Count	396 Count	307 Count
1784736253	407 Count	391 Count	303 Count
1784734450	402 Count	385 Count	299 Count
1784730879	389 Count	375 Count	292 Count
1784729075	384 Count	370 Count	288 Count
1784727272	379 Count	365 Count	284 Count
1784725469	374 Count	359 Count	280 Count
1784723667	370 Count	354 Count	277 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)