SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789975294	216 Count	86 Count
1789973613	211 Count	84 Count
1789971932	206 Count	84 Count
1789970251	202 Count	82 Count
1789968571	196 Count	81 Count
1789966890	191 Count	79 Count
1789965458	183 Count	78 Count
1789963778	177 Count	76 Count
1789962097	172 Count	74 Count
1789960416	166 Count	72 Count
1789958735	161 Count	71 Count
1789957054	156 Count	64 Count
1789955374	152 Count	63 Count
1789953693	148 Count	61 Count
1789952012	143 Count	59 Count
1789950331	137 Count	58 Count
1789948650	132 Count	56 Count
1789946970	126 Count	54 Count
1789945289	121 Count	52 Count
1789943858	113 Count	50 Count
1789942177	107 Count	48 Count
1789940496	102 Count	46 Count
1789938815	97 Count	44 Count
1789937135	91 Count	42 Count
1789935454	87 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)