SQ7AYZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7AYZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788580513	87 Count	53 Count	53 Count
1788578712	84 Count	51 Count	51 Count
1788576906	80 Count	48 Count	48 Count
1788575101	77 Count	46 Count	46 Count
1788573301	73 Count	43 Count	43 Count
1788571500	70 Count	41 Count	41 Count
1788569699	66 Count	38 Count	38 Count
1788567899	62 Count	35 Count	35 Count
1788566115	59 Count	33 Count	33 Count
1788564315	55 Count	30 Count	30 Count
1788562514	52 Count	28 Count	28 Count
1788560713	49 Count	26 Count	26 Count
1788558913	46 Count	24 Count	24 Count
1788557112	42 Count	21 Count	21 Count
1788555311	39 Count	19 Count	19 Count
1788553511	37 Count	18 Count	18 Count
1788551710	36 Count	18 Count	18 Count
1788549909	35 Count	18 Count	18 Count
1788548109	33 Count	17 Count	17 Count
1788546308	32 Count	17 Count	17 Count
1788544510	31 Count	17 Count	17 Count
1788542710	30 Count	17 Count	17 Count
1788540909	29 Count	17 Count	17 Count
1788539108	28 Count	17 Count	17 Count
1788537306	27 Count	17 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)