SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780848752	71 Count	434 Count
1780846950	70 Count	433 Count
1780845149	69 Count	431 Count
1780843355	68 Count	430 Count
1780841552	67 Count	395 Count
1780839751	66 Count	394 Count
1780837949	65 Count	393 Count
1780836155	64 Count	392 Count
1780834354	63 Count	391 Count
1780832552	62 Count	390 Count
1780830750	61 Count	389 Count
1780828953	60 Count	388 Count
1780827151	59 Count	383 Count
1780825349	58 Count	382 Count
1780823548	57 Count	381 Count
1780821753	56 Count	380 Count
1780819951	55 Count	379 Count
1780818149	54 Count	378 Count
1780816348	53 Count	376 Count
1780814552	52 Count	374 Count
1780812751	51 Count	373 Count
1780810949	50 Count	372 Count
1780809147	49 Count	369 Count
1780807352	48 Count	362 Count
1780805551	47 Count	357 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)