SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784685691	5 Count	72 Count
1784682090	4 Count	65 Count
1784678489	3 Count	53 Count
1784674888	2 Count	43 Count
1784671290	1 Count	33 Count
1784667688	0 Count	25 Count
1784664088	30 Count	1003 Count
1784660487	29 Count	983 Count
1784656888	28 Count	968 Count
1784653287	27 Count	934 Count
1784649688	26 Count	909 Count
1784646086	25 Count	835 Count
1784642488	24 Count	799 Count
1784638887	23 Count	771 Count
1784635291	22 Count	754 Count
1784631690	21 Count	735 Count
1784628087	20 Count	704 Count
1784624485	19 Count	680 Count
1784620891	18 Count	652 Count
1784617292	17 Count	619 Count
1784613685	16 Count	578 Count
1784610084	15 Count	535 Count
1784606486	14 Count	495 Count
1784602884	13 Count	453 Count
1784599297	12 Count	417 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)