SV2HQL-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV2HQL-7. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Celsius*	Atm_Press*
1777859016	19.5 C	1026.25 hPa
1777849985	20 C	1026.25 hPa
1777840937	19.6 C	962.13 hPa
1777830883	21 C	1024.88 hPa
1777821852	21.1 C	1023.88 hPa
1777812821	19.7 C	1024.63 hPa
1777803790	19.5 C	1026.13 hPa
1777802299	25.8 C	1024.25 hPa
1777802067	32 C	1024.38 hPa
1777795639	16 C	1025.5 hPa
1777795345	14.7 C	961.75 hPa
1777779233	19 C	1024.75 hPa
1777770202	19.1 C	1027.63 hPa
1777761171	20.2 C	1028.25 hPa
1777752140	23.5 C	1027.38 hPa
1777743109	21.7 C	1025.75 hPa
1777734078	19.7 C	1026.38 hPa
1777725047	22.4 C	1024.5 hPa
1777630776	18.6 C	1024.88 hPa
1777627688	16.3 C	1025.5 hPa
1777618346	21.8 C	1022 hPa
1777609315	20.2 C	1024.88 hPa
1777600284	20.4 C	1024.38 hPa
1777591253	22.3 C	1024.25 hPa
1777582222	24.5 C	1023.63 hPa

*Used Equation Coefficients:

Celsius: 0, 0.1, -50

Atm_Press: 0, 0.125, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)