XE2VP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2VP. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	VoltWX*	TempI*
1772632398	14.1 Volt	30 C
1772632079	14.1 Volt	29.5 C
1772631781	14.1 Volt	29 C
1772631779	14.1 Volt	29 C
1772631479	14.1 Volt	28.5 C
1772631181	14.1 Volt	28.5 C
1772631179	14.1 Volt	28.5 C
1772630580	14.1 Volt	28 C
1772630579	14.1 Volt	28 C
1772630279	14.1 Volt	28 C
1772629980	14.1 Volt	28 C
1772629979	14.1 Volt	28 C
1772629679	14.1 Volt	28 C
1772629380	14.1 Volt	28 C
1772629379	14.1 Volt	28 C
1772629079	14.1 Volt	28 C
1772628805	14.1 Volt	28 C
1772628479	14.1 Volt	27.5 C
1772628181	14.1 Volt	27.5 C
1772628179	14.1 Volt	27.5 C
1772627879	14.1 Volt	27.5 C
1772627579	14.1 Volt	27.5 C
1772627279	14.1 Volt	28 C
1772626981	14.1 Volt	29 C
1772626706	14.1 Volt	29 C

*Used Equation Coefficients:

VoltWX: 0, 0.075, 0

VoltFue: 0, 0.1, 0

MilAmp: 0, 19.5, 0

TempEx: 0, 0.5, -64

TempI: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)