SP3MCY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3MCY-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1784759496	500 Count	67 Count
1784757695	500 Count	67 Count
1784755895	500 Count	67 Count
1784754095	500 Count	67 Count
1784752294	500 Count	67 Count
1784750494	500 Count	67 Count
1784748694	500 Count	67 Count
1784746894	498 Count	67 Count
1784745094	495 Count	67 Count
1784743295	491 Count	66 Count
1784741495	491 Count	66 Count
1784739695	491 Count	66 Count
1784737894	491 Count	66 Count
1784734294	491 Count	66 Count
1784732494	491 Count	66 Count
1784730694	491 Count	66 Count
1784728893	491 Count	66 Count
1784727092	491 Count	66 Count
1784725292	491 Count	66 Count
1784723492	491 Count	66 Count
1784721692	491 Count	66 Count
1784719892	491 Count	66 Count
1784718092	491 Count	66 Count
1784716292	491 Count	66 Count
1784714492	491 Count	66 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)