PA3FUA-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3FUA-7. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Celsius*	Atm_Press*
1785165405	33 C	1018.75 hPa
1785165356	33 C	1018.5 hPa
1785165176	32.9 C	1017.63 hPa
1785165142	32.9 C	1017.88 hPa
1785165083	32.9 C	1017.38 hPa
1785165059	32.9 C	1017.75 hPa
1785164995	32.9 C	1018.38 hPa
1785164941	32.9 C	1017.88 hPa
1785164917	32.9 C	1017.75 hPa
1785164697	33 C	1017.5 hPa
1785164609	32.9 C	1018.88 hPa
1785164375	32.9 C	1018.25 hPa
1785164247	32.8 C	1018.63 hPa
1785164183	32.6 C	1018.75 hPa
1785164060	32.4 C	1019.13 hPa
1785163996	32.2 C	1019.38 hPa
1785163946	32.2 C	1019 hPa
1785163915	31.9 C	1018.38 hPa
1785163891	31.9 C	1019.38 hPa
1785163867	31.7 C	1019.88 hPa
1785163843	31.7 C	1019 hPa
1785163779	31.5 C	1017.88 hPa
1785163755	31.4 C	1018.13 hPa
1785163731	31.4 C	1019 hPa
1785163667	31.4 C	1019.13 hPa

*Used Equation Coefficients:

Celsius: 0, 0.1, -50

Atm_Press: 0, 0.125, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)