EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784674010	8 Count	418 Count
1784672206	7 Count	358 Count
1784670403	6 Count	302 Count
1784668600	5 Count	257 Count
1784666796	4 Count	211 Count
1784664993	3 Count	164 Count
1784663203	2 Count	119 Count
1784661419	1 Count	79 Count
1784659616	0 Count	39 Count
1784657812	18 Count	1032 Count
1784656009	17 Count	991 Count
1784654206	16 Count	937 Count
1784652402	15 Count	865 Count
1784650599	14 Count	776 Count
1784648796	13 Count	713 Count
1784646992	12 Count	655 Count
1784645189	11 Count	593 Count
1784643418	10 Count	520 Count
1784641615	9 Count	453 Count
1784639811	8 Count	400 Count
1784638008	7 Count	354 Count
1784636205	6 Count	298 Count
1784634401	5 Count	255 Count
1784632598	4 Count	218 Count
1784630795	3 Count	172 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)