SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787569959	439 Count	470 Count	80 Count
1787568158	438 Count	470 Count	80 Count
1787564557	436 Count	470 Count	80 Count
1787562756	435 Count	470 Count	80 Count
1787560956	434 Count	470 Count	80 Count
1787559155	433 Count	470 Count	80 Count
1787557354	432 Count	470 Count	80 Count
1787555554	431 Count	470 Count	80 Count
1787553753	430 Count	470 Count	80 Count
1787551960	429 Count	470 Count	80 Count
1787550159	428 Count	470 Count	80 Count
1787548359	427 Count	470 Count	80 Count
1787546558	426 Count	470 Count	80 Count
1787544757	425 Count	470 Count	80 Count
1787542957	424 Count	470 Count	80 Count
1787541156	423 Count	470 Count	80 Count
1787539355	422 Count	470 Count	80 Count
1787537555	421 Count	470 Count	80 Count
1787535754	420 Count	470 Count	80 Count
1787533953	419 Count	470 Count	80 Count
1787532153	418 Count	470 Count	80 Count
1787530360	417 Count	470 Count	80 Count
1787528559	416 Count	470 Count	80 Count
1787526758	415 Count	470 Count	80 Count
1787524958	414 Count	470 Count	80 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)