OH7JHF-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OH7JHF-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784214541	156	189	217	230	176
1784214498	156	190	223	225	162
1784214237	156	190	217	230	175
1784213564	156	190	223	240	188
1784213302	156	189	222	237	177
1784213158	156	191	225	231	174
1784212228	156	190	223	219	167
1784212138	156	189	222	225	162
1784212002	156	189	215	210	163
1784211756	156	189	215	230	168
1784211603	156	189	222	225	169
1784211467	156	188	214	221	178
1784211308	156	189	222	238	185
1784210807	156	190	216	210	161
1784208083	157	190	223	240	187
1784202908	156	176	222	237	176
1784197434	156	193	216	230	175
1784197351	156	194	215	209	163
1784195588	156	193	216	229	174
1784194213	156	185	218	231	176
1784193744	156	195	216	217	171
1784190995	156	186	212	227	171
1784190711	156	205	220	215	163
1784190234	156	181	212	227	172
1784188199	155	182	213	214	168

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)