OE5MAO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5MAO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1761881037	0 C deg	21.7 C deg
1761879222	0 C deg	21.7 C deg
1761877407	0 C deg	21.7 C deg
1761875592	0 C deg	21.8 C deg
1761873777	0 C deg	21.8 C deg
1761871962	0 C deg	21.8 C deg
1761870147	0 C deg	21.8 C deg
1761868339	0 C deg	21.8 C deg
1761866517	0 C deg	21.8 C deg
1761864702	0 C deg	21.9 C deg
1761862887	0 C deg	21.9 C deg
1761861072	0 C deg	21.9 C deg
1761859257	0 C deg	21.9 C deg
1761855622	0 C deg	21.9 C deg
1761851992	0 C deg	21.9 C deg
1761850177	0 C deg	21.9 C deg
1761848362	0 C deg	21.8 C deg
1761846547	0 C deg	21.8 C deg
1761844735	0 C deg	21.7 C deg
1761842920	0 C deg	21.7 C deg
1761839288	0 C deg	21.6 C deg
1761837473	0 C deg	21.5 C deg
1761835658	0 C deg	21.4 C deg
1761833843	0 C deg	21.3 C deg
1761832029	0 C deg	21.2 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)