VK3AFQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3AFQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1776872522	709 Count	8 Count
1776870718	708 Count	8 Count
1776868914	707 Count	8 Count
1776867110	706 Count	8 Count
1776865306	705 Count	8 Count
1776863501	704 Count	8 Count
1776861696	703 Count	8 Count
1776859943	702 Count	8 Count
1776858139	701 Count	8 Count
1776856334	700 Count	8 Count
1776854530	699 Count	8 Count
1776852726	698 Count	8 Count
1776850923	697 Count	8 Count
1776849117	696 Count	8 Count
1776847312	695 Count	8 Count
1776845508	694 Count	8 Count
1776843703	693 Count	8 Count
1776841899	692 Count	8 Count
1776840094	691 Count	8 Count
1776838341	690 Count	8 Count
1776836537	689 Count	8 Count
1776834732	688 Count	8 Count
1776832928	687 Count	8 Count
1776831123	686 Count	8 Count
1776829319	685 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)