F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787566799	929 Count	748 Count	636 Count
1787564999	928 Count	748 Count	636 Count
1787563198	927 Count	748 Count	636 Count
1787561397	926 Count	748 Count	636 Count
1787559596	925 Count	748 Count	636 Count
1787557796	892 Count	716 Count	604 Count
1787555995	860 Count	665 Count	573 Count
1787554194	858 Count	664 Count	572 Count
1787552394	856 Count	657 Count	571 Count
1787550593	773 Count	555 Count	489 Count
1787548792	772 Count	555 Count	489 Count
1787546991	771 Count	555 Count	489 Count
1787545198	770 Count	555 Count	489 Count
1787543398	769 Count	555 Count	489 Count
1787541597	768 Count	555 Count	489 Count
1787539796	767 Count	555 Count	489 Count
1787537995	766 Count	555 Count	489 Count
1787536195	765 Count	555 Count	489 Count
1787534394	764 Count	555 Count	489 Count
1787532593	763 Count	555 Count	489 Count
1787530793	762 Count	555 Count	489 Count
1787528992	761 Count	555 Count	489 Count
1787527220	760 Count	555 Count	489 Count
1787525391	759 Count	555 Count	489 Count
1787523597	758 Count	555 Count	489 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)