SP3HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765522175	899 Count	16 Count	15 Count
1765520374	898 Count	16 Count	15 Count
1765518573	897 Count	16 Count	15 Count
1765516773	896 Count	16 Count	15 Count
1765514972	895 Count	16 Count	15 Count
1765513171	894 Count	16 Count	15 Count
1765511370	893 Count	16 Count	15 Count
1765509569	892 Count	16 Count	15 Count
1765507768	891 Count	16 Count	15 Count
1765504175	889 Count	16 Count	15 Count
1765502374	888 Count	16 Count	15 Count
1765500573	887 Count	16 Count	15 Count
1765498772	886 Count	16 Count	15 Count
1765496972	885 Count	16 Count	15 Count
1765495171	884 Count	16 Count	15 Count
1765493370	883 Count	16 Count	15 Count
1765491569	882 Count	16 Count	15 Count
1765489768	881 Count	16 Count	15 Count
1765487968	880 Count	16 Count	15 Count
1765486167	879 Count	16 Count	15 Count
1765484366	878 Count	16 Count	15 Count
1765482575	877 Count	16 Count	15 Count
1765480774	876 Count	16 Count	15 Count
1765478973	875 Count	16 Count	15 Count
1765477173	874 Count	16 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)