SQ7RJZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7RJZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785295866	343 Count	655 Count
1785294065	342 Count	655 Count
1785292264	341 Count	655 Count
1785290463	340 Count	655 Count
1785288663	339 Count	655 Count
1785286862	338 Count	655 Count
1785285070	337 Count	655 Count
1785283270	336 Count	655 Count
1785281469	335 Count	655 Count
1785279668	334 Count	655 Count
1785277867	333 Count	655 Count
1785276067	332 Count	655 Count
1785274266	331 Count	655 Count
1785272465	330 Count	655 Count
1785270664	329 Count	655 Count
1785268864	328 Count	655 Count
1785267063	327 Count	655 Count
1785265262	326 Count	655 Count
1785263469	325 Count	655 Count
1785261668	324 Count	655 Count
1785259868	323 Count	655 Count
1785258067	322 Count	655 Count
1785256266	321 Count	655 Count
1785254465	320 Count	655 Count
1785252665	319 Count	655 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)