This is the latest recevied telemetry packets stored in our database for station/object YM2KAP. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Rx1h*
Dg1h*
Eff1h*
Eff*
1784692631
12.73 Volt
1190 Pkt
420 Pkt
74 Pcnt
80 Pcnt
1784692029
12.73 Volt
1190 Pkt
420 Pkt
74 Pcnt
80 Pcnt
1784691433
12.65 Volt
1170 Pkt
390 Pkt
74 Pcnt
80 Pcnt
1784690830
12.65 Volt
1180 Pkt
370 Pkt
74 Pcnt
80 Pcnt
1784690226
12.65 Volt
1200 Pkt
380 Pkt
74 Pcnt
80 Pcnt
1784689629
12.65 Volt
1170 Pkt
360 Pkt
74 Pcnt
80 Pcnt
1784689035
12.65 Volt
1180 Pkt
350 Pkt
74 Pcnt
80 Pcnt
1784688422
12.65 Volt
1190 Pkt
360 Pkt
74 Pcnt
80 Pcnt
1784687824
12.65 Volt
1180 Pkt
360 Pkt
75 Pcnt
80 Pcnt
1784687229
12.65 Volt
1180 Pkt
370 Pkt
76 Pcnt
80 Pcnt
1784686626
12.65 Volt
1220 Pkt
360 Pkt
78 Pcnt
80 Pcnt
1784686032
12.65 Volt
1260 Pkt
380 Pkt
78 Pcnt
80 Pcnt
*Used Equation Coefficients:
Vin: 0, 0.074, 0
Rx1h: 0, 10, 0
Dg1h: 0, 10, 0
Eff1h: 0, 1, 0
Eff: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)