SQ3DVQ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3DVQ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1753648525	760 Count	522 Count
1753646928	759 Count	522 Count
1753645127	758 Count	522 Count
1753643326	757 Count	522 Count
1753641526	756 Count	522 Count
1753639725	755 Count	522 Count
1753637925	754 Count	522 Count
1753636124	753 Count	522 Count
1753634322	752 Count	522 Count
1753632521	751 Count	522 Count
1753632504	750 Count	522 Count
1753632376	749 Count	522 Count
1753630575	748 Count	522 Count
1753628774	747 Count	522 Count
1753626984	746 Count	522 Count
1753625184	745 Count	522 Count
1753623383	744 Count	522 Count
1753621582	743 Count	522 Count
1753619781	742 Count	522 Count
1753617980	741 Count	522 Count
1753616179	740 Count	519 Count
1753612578	738 Count	518 Count
1753610776	737 Count	518 Count
1753608976	736 Count	518 Count
1753607175	735 Count	518 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)