SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789952012	15 Count	84 Count	0 Count
1789950811	14 Count	77 Count	0 Count
1789948410	12 Count	69 Count	0 Count
1789947209	11 Count	63 Count	0 Count
1789944808	9 Count	55 Count	0 Count
1789943608	8 Count	43 Count	0 Count
1789942407	6 Count	40 Count	0 Count
1789941206	5 Count	31 Count	0 Count
1789940019	4 Count	24 Count	0 Count
1789938805	3 Count	21 Count	0 Count
1789937604	2 Count	15 Count	0 Count
1789936404	1 Count	9 Count	0 Count
1789935203	0 Count	6 Count	0 Count
1789934003	220 Count	1004 Count	4 Count
1789932802	219 Count	997 Count	4 Count
1789931601	218 Count	994 Count	4 Count
1789930411	213 Count	989 Count	4 Count
1789929210	212 Count	983 Count	4 Count
1789928009	211 Count	981 Count	4 Count
1789926809	210 Count	975 Count	4 Count
1789925608	209 Count	969 Count	4 Count
1789924408	208 Count	966 Count	4 Count
1789923207	205 Count	961 Count	4 Count
1789922006	198 Count	956 Count	4 Count
1789920806	196 Count	953 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)