SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789973029	838 Count	647 Count	553 Count
1789972128	835 Count	645 Count	551 Count
1789971227	833 Count	644 Count	550 Count
1789970326	830 Count	642 Count	548 Count
1789969424	827 Count	640 Count	546 Count
1789968523	824 Count	638 Count	544 Count
1789967622	821 Count	636 Count	542 Count
1789966721	818 Count	634 Count	540 Count
1789965819	815 Count	632 Count	538 Count
1789964948	813 Count	631 Count	537 Count
1789964047	811 Count	630 Count	536 Count
1789963146	809 Count	629 Count	535 Count
1789962244	807 Count	628 Count	534 Count
1789961343	805 Count	627 Count	533 Count
1789960442	803 Count	626 Count	532 Count
1789959541	801 Count	625 Count	531 Count
1789958639	799 Count	624 Count	530 Count
1789957738	796 Count	622 Count	528 Count
1789956837	794 Count	621 Count	527 Count
1789955935	792 Count	620 Count	526 Count
1789955034	789 Count	618 Count	524 Count
1789954133	787 Count	617 Count	523 Count
1789953231	784 Count	615 Count	521 Count
1789952330	782 Count	614 Count	520 Count
1789951429	779 Count	612 Count	518 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)