EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784691698	20 Count	755 Count
1784689895	19 Count	723 Count
1784688092	18 Count	679 Count
1784686285	17 Count	645 Count
1784684482	16 Count	614 Count
1784682700	15 Count	586 Count
1784680875	14 Count	535 Count
1784679072	13 Count	493 Count
1784677269	12 Count	460 Count
1784675465	11 Count	427 Count
1784673662	10 Count	394 Count
1784671859	9 Count	355 Count
1784670094	8 Count	300 Count
1784668291	7 Count	252 Count
1784666488	6 Count	223 Count
1784664684	5 Count	192 Count
1784662881	4 Count	169 Count
1784661078	3 Count	144 Count
1784659274	2 Count	110 Count
1784657471	1 Count	74 Count
1784655668	0 Count	37 Count
1784653865	20 Count	1027 Count
1784652062	19 Count	993 Count
1784650258	18 Count	964 Count
1784648493	17 Count	933 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)