SQ7FSO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7FSO. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1780551431	312 Count	307 Count	305 Count
1780549630	310 Count	305 Count	303 Count
1780547830	306 Count	301 Count	299 Count
1780546030	304 Count	299 Count	297 Count
1780544230	302 Count	297 Count	295 Count
1780542430	297 Count	292 Count	290 Count
1780540630	295 Count	290 Count	288 Count
1780538830	293 Count	288 Count	286 Count
1780537029	288 Count	283 Count	281 Count
1780535229	279 Count	274 Count	272 Count
1780533429	270 Count	265 Count	263 Count
1780533056	269 Count	264 Count	262 Count
1780531256	267 Count	262 Count	260 Count
1780529829	265 Count	260 Count	258 Count
1780528029	263 Count	258 Count	256 Count
1780526229	261 Count	256 Count	254 Count
1780524428	259 Count	254 Count	252 Count
1780522628	257 Count	252 Count	250 Count
1780520828	255 Count	250 Count	248 Count
1780519028	253 Count	248 Count	246 Count
1780517228	251 Count	246 Count	244 Count
1780515428	249 Count	244 Count	242 Count
1780513628	246 Count	241 Count	239 Count
1780511828	244 Count	239 Count	237 Count
1780510030	239 Count	234 Count	232 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)