EB5CGD-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5CGD-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765549462	14 Count	905 Count
1765548442	14 Count	905 Count
1765547422	14 Count	905 Count
1765546402	14 Count	905 Count
1765545382	14 Count	905 Count
1765544362	14 Count	905 Count
1765543342	14 Count	905 Count
1765542322	14 Count	905 Count
1765541302	14 Count	905 Count
1765538241	14 Count	905 Count
1765537221	14 Count	897 Count
1765537040	14 Count	897 Count
1765536020	14 Count	896 Count
1765535000	14 Count	896 Count
1765533980	14 Count	896 Count
1765532960	14 Count	896 Count
1765531940	14 Count	896 Count
1765530920	14 Count	896 Count
1765529900	14 Count	893 Count
1765528880	14 Count	891 Count
1765527860	14 Count	891 Count
1765526840	14 Count	891 Count
1765525820	14 Count	891 Count
1765524800	14 Count	891 Count
1765523780	14 Count	891 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)