F1ZIN-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZIN-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788703711	250 Count	23 Count	21 Count
1788701907	249 Count	23 Count	21 Count
1788700103	248 Count	23 Count	21 Count
1788698299	239 Count	15 Count	13 Count
1788696496	226 Count	3 Count	1 Count
1788694690	225 Count	3 Count	1 Count
1788692886	224 Count	3 Count	1 Count
1788691082	223 Count	3 Count	1 Count
1788689278	222 Count	3 Count	1 Count
1788687521	217 Count	3 Count	1 Count
1788685717	216 Count	3 Count	1 Count
1788683913	215 Count	3 Count	1 Count
1788682109	214 Count	3 Count	1 Count
1788680304	213 Count	3 Count	1 Count
1788678500	212 Count	3 Count	1 Count
1788676696	211 Count	3 Count	1 Count
1788674892	210 Count	3 Count	1 Count
1788673088	209 Count	3 Count	1 Count
1788671284	208 Count	3 Count	1 Count
1788669479	207 Count	3 Count	1 Count
1788667675	206 Count	3 Count	1 Count
1788665918	201 Count	3 Count	1 Count
1788664114	200 Count	3 Count	1 Count
1788662310	199 Count	3 Count	1 Count
1788660506	198 Count	3 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)