SQ3MQD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3MQD-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773109654	469 Count	927 Count
1773108754	468 Count	927 Count
1773107853	467 Count	927 Count
1773106952	466 Count	927 Count
1773106051	465 Count	927 Count
1773105151	464 Count	927 Count
1773104250	463 Count	927 Count
1773103349	462 Count	927 Count
1773102449	461 Count	927 Count
1773101548	460 Count	927 Count
1773100647	459 Count	927 Count
1773099746	458 Count	927 Count
1773098846	457 Count	927 Count
1773097945	456 Count	927 Count
1773097044	455 Count	927 Count
1773096144	454 Count	927 Count
1773095243	453 Count	927 Count
1773094342	452 Count	927 Count
1773093454	451 Count	927 Count
1773092554	450 Count	927 Count
1773091653	449 Count	927 Count
1773090752	448 Count	927 Count
1773089852	447 Count	927 Count
1773088951	446 Count	927 Count
1773088050	445 Count	927 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)