EA5SW-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5SW-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788561024	49 Count	505 Count
1788559223	48 Count	505 Count
1788557430	47 Count	505 Count
1788555629	46 Count	505 Count
1788553829	45 Count	505 Count
1788552028	44 Count	505 Count
1788550227	43 Count	505 Count
1788548426	42 Count	505 Count
1788546626	41 Count	505 Count
1788544825	40 Count	505 Count
1788543024	39 Count	505 Count
1788541224	38 Count	488 Count
1788539423	37 Count	459 Count
1788537622	36 Count	441 Count
1788535829	35 Count	429 Count
1788534029	34 Count	429 Count
1788532228	33 Count	429 Count
1788530427	32 Count	429 Count
1788528626	31 Count	429 Count
1788526826	30 Count	410 Count
1788525025	29 Count	393 Count
1788523224	28 Count	353 Count
1788521424	27 Count	332 Count
1788519623	26 Count	306 Count
1788517835	25 Count	273 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)