SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765512501	19 Count	218 Count	15 Count
1765511600	16 Count	180 Count	13 Count
1765510700	11 Count	138 Count	9 Count
1765509799	7 Count	87 Count	6 Count
1765508898	2 Count	46 Count	2 Count
1765507998	97 Count	1014 Count	66 Count
1765507097	94 Count	965 Count	64 Count
1765506196	93 Count	962 Count	64 Count
1765505295	89 Count	924 Count	61 Count
1765504395	85 Count	887 Count	58 Count
1765503494	81 Count	833 Count	55 Count
1765502593	78 Count	795 Count	53 Count
1765501692	74 Count	755 Count	50 Count
1765500792	71 Count	716 Count	48 Count
1765499891	66 Count	662 Count	44 Count
1765498990	63 Count	625 Count	42 Count
1765498089	62 Count	621 Count	42 Count
1765497189	59 Count	578 Count	40 Count
1765496288	54 Count	532 Count	36 Count
1765495387	51 Count	496 Count	34 Count
1765493586	43 Count	412 Count	28 Count
1765491785	34 Count	328 Count	21 Count
1765490900	27 Count	312 Count	19 Count
1765489999	26 Count	309 Count	19 Count
1765489098	22 Count	254 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)