EX0QKT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EX0QKT-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782114756	426 Count	17 Count	17 Count
1782112956	426 Count	17 Count	17 Count
1782111156	426 Count	17 Count	17 Count
1782109356	426 Count	17 Count	17 Count
1782107556	426 Count	17 Count	17 Count
1782105756	426 Count	17 Count	17 Count
1782103956	426 Count	17 Count	17 Count
1782102156	426 Count	17 Count	17 Count
1782100356	426 Count	17 Count	17 Count
1782098556	426 Count	17 Count	17 Count
1782096756	426 Count	17 Count	17 Count
1782094956	426 Count	17 Count	17 Count
1782093156	426 Count	17 Count	17 Count
1782091356	426 Count	17 Count	17 Count
1782089556	426 Count	17 Count	17 Count
1782087756	426 Count	17 Count	17 Count
1782085956	426 Count	17 Count	17 Count
1782084164	426 Count	17 Count	17 Count
1782082356	426 Count	17 Count	17 Count
1782080556	426 Count	17 Count	17 Count
1782078757	426 Count	17 Count	17 Count
1782076957	426 Count	17 Count	17 Count
1782075157	426 Count	17 Count	17 Count
1782073357	426 Count	17 Count	17 Count
1782071557	426 Count	17 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)