OK1LOL-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1753563092	52 Count	192 Count
1753561289	51 Count	189 Count
1753559522	50 Count	184 Count
1753557719	49 Count	179 Count
1753555916	48 Count	176 Count
1753554113	47 Count	174 Count
1753552310	46 Count	171 Count
1753550507	45 Count	167 Count
1753548721	44 Count	164 Count
1753546900	43 Count	159 Count
1753545097	42 Count	157 Count
1753543294	41 Count	153 Count
1753541491	40 Count	150 Count
1753539688	39 Count	146 Count
1753537919	38 Count	142 Count
1753536116	37 Count	139 Count
1753534313	36 Count	136 Count
1753532510	35 Count	133 Count
1753530706	34 Count	130 Count
1753528903	33 Count	125 Count
1753527100	32 Count	121 Count
1753525297	31 Count	114 Count
1753523494	30 Count	109 Count
1753521691	29 Count	105 Count
1753519888	28 Count	102 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)